AMCC 9000 Manual de usuario descargar pdf (Pagina 100)

Driver Installation Under FreeBSD

92 3ware 9000 Series Serial ATA RAID Controller Installation Guide

TWA_FIRMWARE_FLASH opt_twa.h

and the following line to your kernel configuration file

(“custom” in the example above):

options TWA_FLASH_FIRMWARE

j If you intend to enable printing of debug messages in the

driver, add the following line to /sys/conf/options:

TWA_DEBUG opt_twa.h

and the following line to your kernel configuration file

(“custom” in the example above):

options TWA_DEBUG=<number from 0 to 10>

Specifying 0 in the above line prints no debug messages,

whereas specifying 10 prints a LOT of debug messages.

11 Rebuild the kernel and install the new kernel.

12 Reboot with the rebuilt kernel.

Installing the 3ware Driver on a

FreeBSD System that Boots from a

Different Device

To install the 3ware driver as a module

1 Copy the driver from the 3ware CD-ROM at

/packages/drivers/freebsd/<OS version>

For FreeBSD 4.x, copy the driver into

/modules

For FreeBSD 5.x, copy the driver into

/boot/kernel.

2 Load the driver

kldload twa.ko

If units are present, you should see unit information in the

system log (usually,

/var/log/messages).

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 125 126

Sin comentarios

AMCC 9000 Manual de usuario Pagina 100