AMCC 9000 Manual de usuario descargar pdf (Pagina 97)

Installing the Driver While Installing FreeBSD on the 3ware RAID Controller

www.3ware.com 89

To install the driver as a module

1 Boot with the FreeBSD CD-ROM or diskette.

2 In the sysinstall menu, select Configure > Load KLD module.

Note: Immediately after the OS starts booting from the CD,

insert an MS-DOS floppy with the 3ware driver,

twa.ko, into

the floppy drive. If you do not insert it immediately, sysinstall

may fail to recognize the floppy drive.

3 Load the driver from the floppy drive.

4 Run the FreeBSD installation and reboot.

For instructions on how to install FreeBSD, see the FreeBSD

website, at

http://www.freebsd.org/

5 Remove the floppy disk and the CD.

6 On reboot, escape to the loader menu.

Note: Once again, immediately after the OS starts booting,

insert an MS-DOS floppy with the 3ware driver,

twa.ko, into

the floppy drive. If you do not insert it immediately, the loader

may fail to recognize the floppy drive.

7 At the loader prompt, run 'lsdev' to make sure the floppy drive

has been discovered.

8 Load the driver from the floppy. For example, if the floppy

drive is disk0, type

load disk0:twa.ko

9 Run 'boot'.

The system should now be able to boot.

10 After the system boots up, do the following:

a Create a directory for the floppy.

mkdir /floppy

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 125 126

Sin comentarios

AMCC 9000 Manual de usuario Pagina 97