AMCC 3WARE 9500S Guía de usuario descargar pdf (Pagina 133)

Removing a Unit

www.3ware.com 123

3On the Delete Disk Array screen, review the information about the unit to

make sure it is the one you want to delete.

Figure 56. Deleting a Unit in 3BM

4 Tab to the OK button and press Enter.

You return to the main 3BM screen, and the drives associated with the

unit now appear in the list of Available Drives.

Press F8 to save your changes, or press Esc and then Yes.

Removing a Unit

Removing a unit allows you to safely remove drives from a controller in order

to move the unit to another controller or to store the drives for safekeeping

purposes. This process is sometimes referred to as “array roaming.” Hot swap

carriers are required unless you power down first.

When you remove a unit (in contrast to deleting a unit), information about the

unit remains intact on the drives. This allows the drives to be reassembled into

a unit again on this controller, or if moved to another controller.

Remember: The unit is not actually deleted and no data is

overwritten until you press the

F8 key to save your changes, or press

Esc and select Yes when asked if you want to save.

Warning: It is important to remove the unit through software, before removing it

physically. Failure to do so could result in a system crash or hang and may even

corrupt the data and the unit configuration from being reassembled later.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 301 302

Sin comentarios

AMCC 3WARE 9500S Guía de usuario Pagina 133