AMCC 3ware 9650SE-2LP Guía de usuario descargar pdf (Pagina 104)

Configuring Your Controller

92 3ware SAS/SATA RAID Software User Guide, Version 9.5.1

To enable Auto Rebuild through 3DM

1 Choose

Management > Controller Settings from the menu bar in 3DM.

2 In the Other Controller Settings section at the bottom of the screen, select

the

Enabled option for Auto Rebuild.

The page refreshes, and a message at the top confirms the change you

have made.

To enable Auto-Rebuild through 3BM

1 On the main 3BM screen,

Tab to Settings and press Enter.

2 On the pop-up menu, select

Controller Policies and press Enter.

3 On the Policy Settings page,

Tab to the Auto-Rebuild field, press Enter

to display the options, select

Enable and press Enter again to select it.

Tab to OK and press Enter to select it.

The policy is enabled immediately.

Using Auto-Carving for Multi LUN Support

Auto-carving is useful for creating multiple volumes out of large arrays at the

hardware level. Then, when you boot to the operating system, each volume

appears as a different disk drive, simplifying the partitioning required at the

operating system level.

A second use of auto-carving is to gain use of the full capacity of units greater

than 2 TB in older operating systems. This is because Windows 2003 (

32-bit

and 64-bit

without SP1), Windows XP (32-bit), and FreeBSD 4.x, do not

currently recognize unit capacity in excess of 2 TB. For more information see,

http://www.3ware.com/kb/article.aspx?id=13431.

When the Auto-Carving policy is on, any unit larger than a specified size

(known as the carve size) is created as multiple volumes that can be addressed

by the operating system as separate volumes. These chunks are sometimes

known as multiple LUNs (logical units). However, throughout the 3ware

documentation, they are referred to as volumes.

For example, using the default carve size of 2 TB, if the unit is 2.5 TB then it

will contain two volumes, with the first volume containing 2TB and the

second volume containing 0.5 TB. If the unit is 5.0 TB then it will contain 3

volumes, with the first two volumes containing 2 TB each and the last volume

containing 1TB. (

Note: If a specific Boot Volume was also specified in 3BM

or CLI, the first volume will be the size specified for the Boot Volume, and

then the carve size will be applied to the remainder of the unit. For more

information, see “Boot volume size” on page 103.)

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 360 361

Comentarios a estos manuales

Sin comentarios

AMCC 3ware 9650SE-2LP Guía de usuario Pagina 104

Comentarios a estos manuales

Relacionado con productos y manuales para Los controladores raid AMCC 3ware 9650SE-2LP