AMCC 3ware 9650SE-2LP Guía de usuario descargar pdf (Pagina 154)

Configuring Units

142 3ware SAS/SATA RAID Software User Guide, Version 9.5.1

Moving Legacy JBOD Units to a 9000 Controller

The steps for moving legacy JBOD units vary, depending on the operating

system you are using.

To move legacy JBOD units under Windows

1 Install the 9000 controller in your system, while leaving the

8000 controller installed.

2 Install the Windows driver. (For details, see “Driver Installation Under

Windows” on page 33.)

3 Power down the system, disconnect the drives from the 8000 controller

and remove that controller from the system.

4 Attach the drives to the 9000 board.

5 Reboot the system and enter the 3ware 9000 series BIOS (3BM) by

pressing Alt-3. Enable the Export JBOD policy on the Policy screen.

6 Press the

F8 or Esc key to save and exit.

To move legacy JBOD units under Linux or FreeBSD

1 Upgrade your driver to the 9000 series driver.

2 Power down the system, disconnect the drives from the 8000 controller

and remove the controller from the system.

3 Install the 9000 controller and attach the drives to the 9000 board, as

described earlier in this section.

4 Reboot the system and enter the 3ware 9000 series BIOS (3BM) by

pressing Alt-3. Enable the Export JBOD policy on the Policy screen.

5 Press the

F8 or Esc key to save and exit.

Adding a Drive

If you have a hot swap bay or an enclosure with removable trays, you can add

a drive to your system and make it available through 3DM without powering

down the system.

Without hot swap bays, you should not add a drive via 3DM. Instead, power

down the system and add the applicable drives.

Warning: Physically adding a drive without using a hot swap bay and without

powering down your system can result in a system hang or may even damage the

system and the drive.

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 360 361

Sin comentarios

AMCC 3ware 9650SE-2LP Guía de usuario Pagina 154