AMCC 3WARE 9590SE Guía de usuario descargar pdf (Pagina 101)

Enclosure Object Commands

www.3ware.com 95

/cx/e

/slot

show identify

This command is used by 9690SA controllers.

This command shows the identify status of the specified slot. The status can

be either on or off.

Example:

//localhost> c0/e0/slot1 show identify

/e0/slot1 Identify status = on

/slot

set identify=on|off

This command is used by 9690SA controllers.

This command causes the slot to be identified by blinking the LED associated

with it, or turns off identification of the LED for this slot.

Setting identify to on will cause the LED associated with that slot to blink.

Note: This command is equivalent to “/cx/px set identify=on|off” on page 85.

Example:

//localhost> c0/e0/slot1 set identify=on

Sending Identify request to Drive Slot c0/e0/slot0 to [on] ...

Done.

/fan

show

This command is used by the 9690SA controller.

This command shows the information about the specified fan element /fanx in

the specified enclosure cx/ex. The fan name is followed by its status. If a fan

is on and no fault has been detected, the status would indicate OK.

Example:

//localhost> /c0/e0/fan0 show

---Speed---

Fan Status State Step RPM Identify

------------------------------------------------------------

fan0 OK ON 1 2700 Off

/cx/ex/fan

show identify

This command is used by 9690SA controllers.

This command shows the identify status of the specified fan. The status can be

either on or off.

Example:

//localhost> c0/e0/fan1 show identify

c0/e0/fan1 Identify status = on

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 109 110

Sin comentarios

AMCC 3WARE 9590SE Guía de usuario Pagina 101