AMCC 3WARE 9590SE Guía de usuario descargar pdf (Pagina 39)

Controller Object Commands

www.3ware.com 33

default carvesize is 2TB. For more information see, “/cx show memory”,

below.

For operating systems that support units larger than 2TB, there is no need to

set the policy to on unless you want the operating system to have multiple

smaller volumes.

If you use a 32-bit operating system, it is recommended that you keep the

policy on unless you know that your operating system supports disks that are

larger than 2 TB.

When the autocarve policy is off, all newly created units will consist of one

single volume.

Example:

//localhost> /c0 show autocarve

/c0 Auto-Carving Policy = on

/cx show autorebuild

This feature only applies to 9000 series SX/SE/SA model controllers.

This command shows the Auto-Rebuild policy. If the policy is enabled, the

firmware will select drives to use for rebuilding a degraded unit using the

following priority order. For more information, see “/cx set

autorebuild=on|off” on page 58.

1. Smallest usable spare.

2. Smallest usable unconfigured (available) drive.

3. Smallest usable failed drive.

If the policy is disabled, only spare drives will be used for an automatic

rebuild operation.

Example:

//localhost> /c0 show autorebuild

/c0 Auto-Rebuild Policy = on

/cx show bios

This command reports the BIOS version of controller /cx.

Example:

//localhost> /c0 show bios

/c0 BIOS Version = BG9X 2.x

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 109 110

Sin comentarios

AMCC 3WARE 9590SE Guía de usuario Pagina 39