AMCC 3WARE 9590SE Guía de usuario descargar pdf (Pagina 91)

Phy Object Commands

www.3ware.com 85

set identify=on|off

This command applies only to 9000 series SX/SE/SA controllers.

This command sets the LED status of the port to on or off. If identify is set to

on, the firmware activates the setting of the corresponding LED of the port on

the controller and causes it to blink.

Note: This command is equivalent to “/cx/ex/slotx set identify=on|off” on

page 95.

Example:

//localhost> /c0/p5 set identify=on

Setting Port Identify on /c0/p5 to [on] ... Done.

Phy Object Commands

These commands are for 9690SA controllers only.

Phy Object Commands are sent to an instance of a controller phy such as

/c0/phy0.

This command sets the link speed control of the phy. The possible values are

auto, 1.5, and 3.0 for SATA, and auto and 3.0 for SAS. The units are in

Gigabits per second (Gbps).

Syntax

/cx/phyx set link=auto|1.5|3.0

/phy

set link=auto|1.5|3.0

This command sets the link speed for the specified phy. This will control the

speed between the controller and the hard drive or enclosure to which it is

connected.

Example:

//localhost> /c0/phy0 set link=auto

Sending link speed control of /c0/phy0 to [auto] ... Done.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 109 110

Sin comentarios

AMCC 3WARE 9590SE Guía de usuario Pagina 91