AMCC 3WARE 9590SE Guía de usuario descargar pdf (Pagina 28)

Chapter 2. CLI Syntax Reference

22 3ware Serial ATA RAID Controller User Guide

Syntax Overview

The command syntax uses the general form:

Object Command Attributes

Objects are shell commands, controllers, units, ports (drives), BBUs (battery

backup units), and enclosures.

Commands can either select (show, get, present, read) attributes or alter (add,

change, set, write) attributes.

Unit Maintenance Tasks

Start a rebuild /cx/ux start rebuild 68

Start a verify /cx/ux start verify 68

Pause/resume rebuild /cx/ux pause rebuild and /cx/ux

resume rebuild

Stop verify /cx/ux stop verify 69

Enable/disable autoverify /cx/ux set autoverify 70

Identify all drives that make up a

unit by blinking associated LEDs

/cx/ux set identify 64

Port Tasks

Locate drive by blinking an LED /cx/px set identify 85

Check if LED is set to on or off /cx/px show identify 81

View information for specific drive /cx/px show 79

View the status of specific drive /cx/px show status 82

BBU Tasks

Check on charge and condition of

battery

/cx/bbu/ show status 88

Start a test of the battery

/cx/bbu test [quiet] 90

Enclosure Tasks

View information about an

enclosure

/cx/ex show 91

Locate a particular drive slot in an

enclosure by blinking an LED

/cx/ex/slotx set identify 95

Table 5: Common Tasks Mapped to CLI Commands

Task CLI Command Page

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 109 110

Sin comentarios

AMCC 3WARE 9590SE Guía de usuario Pagina 28