AMCC 3WARE 9590SE Guía de usuario descargar pdf (Pagina 56)

Chapter 2. CLI Syntax Reference

50 3ware Serial ATA RAID Controller User Guide

Creating new unit on Controller /c0 ... Done. The new unit is /

c0/u0.

Setting write cache=ON for the new unit ... Done.

Setting default Command Queuing Policy for unit /c0/u0 to [on]

... Done.

After the unit creation, a subsequent ``show'' command for the unit shows the

the volume size(s):

//localhost> /c0/u0 show

Unit UnitType Status %RCmpl %V/I/M VPort Stripe Size(GB)

------------------------------------------------------------------------

u0 RAID-5 OK - - - 64K 1117.56

u0-0 DISK OK - - p2 - 372.519

u0-1 DISK OK - - p3 - 372.519

u0-2 DISK OK - - p4 - 372.519

u0-3 DISK OK - - p5 - 372.519

u0/v0 Volume - - - - - 10

u0/v1 Volume - - - - - 1107.56

rescan [noscan]

This command instructs the controller to rescan all ports, vports, and phys and

reconstitute all units. The controller will update its list of disks, and attempts

to read every DCB (Disk Configuration Block) in order to re-assemble its

view and awareness of logical units. Any newly found unit(s) or drive(s) will

be listed.

noscan is used to not inform the operating system of the unit discovery. The

default is to inform the operating system.

Example:

//localhost> /c1 rescan

Rescanning controller /c1 for units and drives ...Done

Found following unit(s): [/c1/u3]

Found following drive(s): [/c1/p7, /c1/p8]

Note: If you are adding new drives, add them physically before issuing the rescan

commands. Hot swap bays are required unless you first power-down the system to

prevent system hangs and electrical damage.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 109 110

Sin comentarios

AMCC 3WARE 9590SE Guía de usuario Pagina 56