AMCC 3WARE 9590SE Guía de usuario descargar pdf (Pagina 70)

Chapter 2. CLI Syntax Reference

64 3ware Serial ATA RAID Controller User Guide

/cx/ux show initializestatus

This command reports the initializestatus (if any) of the specified unit.

Example:

//localhost> /c0/u5 show initializestatus

/c0/u5 is not initializing, its current state is OK

/cx/ux show name

This feature only applies to 9000 series controllers.

This command reports the name (if any) of the specified unit.

Example:

//localhost> /c0/u5 show name

/c0/u5 name = Joe

/cx/ux show qpolicy

This feature only applies to 9000 series SX/SE/SA model controllers.

This command reports the queue policy of the firmware for SATA drives.

Qpolicy is not applicable to SAS drives. If the queue policy is on, the

firmware utilizes the drive’s queueing policy. If any drives do not support a

queueing policy, this policy will have no effect on those drives.

For a spare unit, drive queuing is not meaningful or applicable. When a spare

becomes part of a true unit during a rebuild, it will adopt the queue policy of

the ''new'' parent unit. Thus, this command does not show the queue policy for

the spare unit type.

Note that currently only NCQ will be enabled, not tag-queueing.

Note that queuing information is not available for SAS drives.

Example:

//localhost> /c0/u5 show qpolicy

/c0/u5 Command Queuing Policy = on

/cx/ux show rebuildstatus

This command reports the rebuildstatus (if any) of the specified unit.

Example:

//localhost> /c0/u5 show rebuildstatus

/c0/u5 is not rebuilding, its current state is OK

If the unit is in the process of migrating, the command will return the

following:

//localhost> /c0/u5 show rebuildstatus

/c0/u5 is not rebuilding, its current state is MIGRATING

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 109 110

Sin comentarios

AMCC 3WARE 9590SE Guía de usuario Pagina 70