AMCC 3WARE 9590SE Guía de usuario descargar pdf (Pagina 77)

Unit Object Commands

www.3ware.com 71

set identify=on|off

This feature only applies to 9000 series SX/SE/SA model controllers.

This feature requires an enclosure that uses an integrated AMCC/3ware CCU

(chassis control unit), such as the 3ware Sidecar, or a chassis from a third-

party vendor. (Check the 3ware web site for a list of chassis vendors that

support enclosure services, as they become available.) For additional

information about enclosure-related commands, see “Enclosure Object

Commands” on page 91.

This command allows you to identify a unit within an enclosure by blinking

the LEDs associated with the drive slots of the specified unit.

Example:

//localhost> /c0/u0 set identify=on

Sending Identify request for unit /c0/u0 to [on] ... Done.

set ignoreECC=on|off

This feature only applies to 9000 series controllers.

This command allows you to set the ignoreECC policy for a given unit.

When ignoreECC policy is set to off, if a rebuild process encounters bad

sectors on the source disk, the rebuild will fail. When ignoreECC is set to on,

such errors are ignored, and the rebuild will continue. When you use

ignoreECC, a file system check is recommended following the rebuild, to

insure data integrity.

By default, ignoreECC is off.

See Table 8, “Supported Model-Unit Types for ignoreECC,” on page 49

set name=

string

This command allows you to name the unit with an arbitrary name. You can

use this name in conjunction with the unit serial number to cross-reference

with the unit. The system does not check to ensure uniqueness of names, so be

careful to assign different names to each unit.

Note: The unit’s serial number is automatically assigned when the unit is created

and is not changeable.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 109 110

Sin comentarios

AMCC 3WARE 9590SE Guía de usuario Pagina 77