AMCC 3WARE 9590SE Guía de usuario descargar pdf (Pagina 85)

Port Object Commands

www.3ware.com 79

Port Object Commands

Port Object Messages are commands that provide information and perform

actions related to a specific disk, attached to a port (or virtual port), such as /

c0/p0. You use port object commands for such tasks as seeing the status,

model, or serial number of the drive.

Syntax

/cx/px show

/cx/px show attribute [attribute ...] where attributes are:

capacity|firmware|identify (9000 series SX/SE/SA only)|

lspeed (9000 series SX/SE/SA only)|model|

ncq (9000 series SX/SE/SA only)|serial|smart|status|

identify (9000 series SX/SE/SA only)|

driveinfo (9690SA only)

/cx/px show all

/cx/px remove [noscan][quiet]

/cx/px set identify=on|off (9000 series SX/SE/SA only)

show

This command shows summary information about the specified disk attached

to port /cx/px.

Example for 9650SE and earlier controllers:

//localhost> /c1/p5 show

Port Status Unit Size Blocks Serial

---------------------------------------------------------

p5 OK u0 149.05 GB 312581808 3JS0L9QW

The above output indicates that port 5 of controller 1 is attached to one disk

with status OK participating in unit 0.

Example for 9690SA controller:

Note that in this case the summary information is in a slightly different format

//localhost> /c3/p1 show

VPort Status Unit Size Type Phy Encl-Slot Model

--------------------------------------------------------------------------

p1 OK u0 149.05 GB SATA 0 - WDC WD1600JS-22NCB1a

The above output indicates that virtual port (VPort) 1 is associated with a

SATA disk that has a status of OK and is part of unit 0. It also indicates that it

is associated with controller phy 0, and is directly attached (that is—it is not in

an enclosure).

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 109 110

Sin comentarios

AMCC 3WARE 9590SE Guía de usuario Pagina 85