AMCC 3WARE 9590SE Guía de usuario descargar pdf (Pagina 104)

Chapter 2. CLI Syntax Reference

98 3ware Serial ATA RAID Controller User Guide

Setting identify to on will cause the LED associated with that temp sensor to

blink.

Example:

//localhost> c0/e0/temp1 set identify=on

Sending Identify request to Temp Sensor c0/e0/temp1 to [on] ...

Done.

Help Commands

The Help commands provides brief on-line help.

You can get overview help by typing Help at the top-level prompt. This

displays a brief definition of commands. (For an example, see the discussion

of the command “help” on page 100.)

You can also get help with specific commands, by entering help before an

object name, or by typing a question mark (?) at the point in a command

where you are uncertain what the attributes are.

Help with specific commands

If you enter the help command at the top level, you are considered to be in the

Shell Object, and the help command will provide help on the Shell commands

focus, show, flush, rescan, and commit. Using the help command on objects

(such as /cx, /cx/ux, /cx/px, /cx/bbu, /ex, /ex/slotx, /ex/fanx, and /ex/tempx),

displays all possible sub-commands associated with the object.

For example: help on the controller object /cx, will display all the sub-

commands associated with the controller /cx, like this:

//localhost> help /cx

/cx show

/cx show attribute [attribute ...] where attribute is:

achip|allunitstatus|autocarve|autorebuild (9000 series

SX/SE/SA only)|bios|carvesize(9KSX/SE/SA only)|

ctlbus(9KSX/SE/SA only)|driver|

unitstatus|ondegrade(9000S only)

/cx show all where all means attributes and configurations.

/cx show diag

/cx show alarms [reverse]

/cx show rebuild (9000 series)

/cx show verify (9000 series)

/cx show selftest (9000 series)

/cx show phy (9690SA only)

/cx add type=<RaidType> disk=<p:-p..> [stripe=<Stripe>]

[noscan]

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 110

Sin comentarios

AMCC 3WARE 9590SE Guía de usuario Pagina 104